Simplisafe Doorbell 90 degree Swivel Mount Adjustable Tilting Bracket

Description

Mount anywhere and get the perfect viewing angle for your doorbell. See the floor area for packages and see people at the same time. Mount on any surface - vinyl, hardie board, brick, stone, narrow aluminum trim, wood trim, etc.'
OTHER OPTIONS AVAILABLE FOR DIFFICULT INSTALLATIONS
Instructional Video on Installation - Installation shows is with backplate- backplate is not required -
https://youtu.be/2r_NqZk3dE0
DOORBELL NOT INCLUDED.
Fits only Simplisafe Doorbell
The swiveling mount can rotate in just about any direction from 15 to 90 degrees. Really it can rotate 15-90 then 105 to 180. It can look left or right, tilt up and down.
PLEASE email me a picture before purchase to make sure you are ordering the correct doorbell type and if a backplate is recommended. (Take picture of doorbell box if not installed, and take picture of the current doorbell from the position of where you want the doorbell to view)
Mount can be installed horizontally as well as vertically to fit in very narrow situations.
Everything is printed with high quality PETG
Swivel has a hole to allow wires to pass through the back. Screws are included to mount and secure the perfect angle so It doesn’t move when bell is pressed.
Backplates are optional. Additional colors are optional. Black is the standard color. Backplates are an inverted box to allow for wires to pass or to cover large holes left by old doorbell. There is room for small wire nuts in the box.
Request a customization if you want a different color than black. White is more, other colors more, and stainable wood more.
Small Backplate is 2.5in x 4in
Medium Bakplate 3 x 4.5
Large Backplate 3.5 x 5
XL Backplate is 4.25 x 6.25
Narrow Backplate is 3/4 in wide at bottom and transitions to 1.8in wide. .43in tall. Can custom make taller
Tall Narrow Backplate gives 1in of sidewall clearance. Before the translation to 1.8in wide.
Offset Backplate - backplate is 3/4in wide at bottom and offset to be flush on one side.
Also Can customize Base- To Move bolt holes to your dimensions - message me for info
Have adapter plate for 2-3/16 Hole Spacing in both doorbell base size (7/8" x 2-7/8")
or Standard base size with 2-3/16 Hole spacing
Message me for all your 3d printing needs.
****The 90 degrees is relative, and it might be slightly less, but this listing provides a doorbell bracket that can work in the 90 degree position relative to the wall. Actual angle can vary depending on the position of the bracket .
****While 3D printing provides really good production quality parts, there are often imperfections that may be found on the prints. These do not impair the function and rarely affect the aesthetics. But if your not happy with the quality, please text, email, or message me before leaving a review.